Epson R320 Waste Ink Counter Reset
When the Epson R320 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.
During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson R320 uses a software counter to estimate pad saturation and locks printing at a set threshold.
Why the Epson R320 Stops Printing (Waste Counter Limit)
С Wic Reset Connect, you can reset the Epson R320 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.
Epson R320 Ink Pad Counter Reset – Quick Steps
- Стъпка 1: Prepare a Windows PC + USB cable and connect Epson R320 directly. Keep Internet enabled for validation.
- Стъпка 2: Изпълнявайте Wic Reset Connect as Administrator and confirm Epson R320 is detected.
- Стъпка 3: Use the key to reset the counter, wait for completion, then restart Epson R320 to finalize.
Most Epson R320 waste counter resets finish in ~1–2 minutes.
Преди да започнете
- Windows 7/8/10/11 PC
- Стабилна интернет връзка по време на нулиране
- Валиден Wic Reset Свържете ключа за нулиране
- Необходима е USB връзка (не се поддържа Wi-Fi нулиране)
Отстраняване на неизправности
- Опитайте с друг USB кабел (някои кабели са само за зареждане).
- Затворете Epson Status Monitor или други помощни програми за принтера.
- Използвайте директна USB връзка (избягвайте концентратори).
- Временно деактивирайте VPN/прокси, ако валидирането е неуспешно.
- Рестартирайте принтера и компютъра, след което опитайте отново.
Guide prepared for Epson R320 – Waste Ink Counter Reset using Wic Reset Connect.