Epson R320 Waste Ink Counter Reset
When the Epson R320 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.
During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson R320 uses a software counter to estimate pad saturation and locks printing at a set threshold.
Why the Epson R320 Stops Printing (Waste Counter Limit)
与 Wic Reset Connect, you can reset the Epson R320 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.
Epson R320 Ink Pad Counter Reset – Quick Steps
- 步骤 1： Prepare a Windows PC + USB cable and connect Epson R320 directly. Keep Internet enabled for validation.
- 步骤 2： 运行 Wic Reset Connect as Administrator and confirm Epson R320 is detected.
- 步骤 3： Use the key to reset the counter, wait for completion, then restart Epson R320 to finalize.
Most Epson R320 waste counter resets finish in ~1–2 minutes.
开始之前
- Windows 7/8/10/11 电脑
- 重置期间稳定的互联网连接
- 有效 Wic 复位连接复位键
- 需要 USB 连接（不支持 Wi-Fi 重置）
故障排除
- 试试另一条 USB 电缆（有些电缆只能充电）。.
- 关闭 Epson 状态监视器或其他打印机实用程序。.
- 使用直接 USB 连接（避免使用集线器）。.
- 如果验证失败，则暂时禁用 VPN/代理。.
- 重新启动打印机和电脑，然后再试一次。.
Guide prepared for Epson R320 – Waste Ink Counter Reset using Wic Reset Connect.