Epson R320 Waste Ink Counter Reset

When the Epson R320 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson R320 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson R320 Stops Printing (Waste Counter Limit)

Med Wic Reset Connect, you can reset the Epson R320 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Epson R320 Ink Pad Counter Reset – Quick Steps

1. Trin 1: Prepare a Windows PC + USB cable and connect Epson R320 directly. Keep Internet enabled for validation.
2. Trin 2: Løb Wic Reset Connect as Administrator and confirm Epson R320 is detected.
3. Trin 3: Use the key to reset the counter, wait for completion, then restart Epson R320 to finalize.

Most Epson R320 waste counter resets finish in ~1–2 minutes.

Før du begynder

• Windows 7/8/10/11 PC
• Stabil internetforbindelse under nulstilling
• Gyldig Wic-nulstilling Tilslut nulstillingsnøgle
• USB-forbindelse påkrævet (Wi-Fi-nulstilling understøttes ikke)

Fejlfinding

• Prøv et andet USB-kabel (nogle kabler er kun til opladning).
• Luk Epson Status Monitor eller andre printerværktøjer.
• Brug en direkte USB-forbindelse (undgå hubs).
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Genstart printeren og pc'en, og prøv igen.