Epson R320 Waste Ink Counter Reset

When the Epson R320 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson R320 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson R320 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson R320 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Epson R320 Ink Pad Counter Reset – Quick Steps

1. Adım 1: Prepare a Windows PC + USB cable and connect Epson R320 directly. Keep Internet enabled for validation.
2. Adım 2: Run Wic Reset Connect as Administrator and confirm Epson R320 is detected.
3. Adım 3: Use the key to reset the counter, wait for completion, then restart Epson R320 to finalize.

Most Epson R320 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)

Troubleshooting

• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.
• Restart printer and PC, then try again.