Epson ET-2870 Waste Ink Counter Reset

When the Epson ET-2870 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2870 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson ET-2870 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson ET-2870 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson ET-2870 Waste Ink Counter in 3 Steps

1. Étape 1 : Connect Epson ET-2870 to a Windows computer with a stable Internet connection using a USB cable.
2. Étape 2 : Start Wic Reset Connect in Administrator mode and wait until Epson ET-2870 appears in the device list.
3. Étape 3 : Use the key to reset the counter, wait for completion, then restart Epson ET-2870 to finalize.

Most Epson ET-2870 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.
• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.