Epson ET-2870 Waste Ink Counter Reset

When the Epson ET-2870 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2870 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson ET-2870 Waste Ink Counter

S Wic Reset Connect, you can reset the Epson ET-2870 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Tipični znakovi

• Pisač odbija ispisati čak i kad je tinte dovoljno.
• Epson Status Monitor prikazuje upozorenje na održavanje
• Treptajuća svjetla i blokirani poslovi
• Uređaj je zaključan dok se ne izvrši resetiranje.

Reset Epson ET-2870 Waste Ink Counter in 3 Steps

1. Korak 1: Connect Epson ET-2870 to a Windows computer with a stable Internet connection using a USB cable.
2. Korak 2: Počni Wic Reset Connect in Administrator mode and wait until Epson ET-2870 appears in the device list.
3. Korak 3: Use the key to reset the counter, wait for completion, then restart Epson ET-2870 to finalize.

Most Epson ET-2870 waste counter resets finish in ~1–2 minutes.

Ako se pisač ne detektira

• Koristite izravno USB-povezivanje (izbjegavajte USB-hubove).
• Ponovno pokrenite pisač i računalo, zatim pokušajte ponovno.
• Pokrenite aplikaciju kao administrator.
• Isprobajte drugi USB kabel (neki kabeli služe samo za punjenje).
• Zatvorite Epson Status Monitor ili druge uslužne programe za pisač.