Epson ET-2870 Waste Ink Counter Reset
When the Epson ET-2870 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.
During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2870 uses a software counter to estimate pad saturation and locks printing at a set threshold.
Understanding the Epson ET-2870 Waste Ink Counter
S Wic Reset Connect, you can reset the Epson ET-2870 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.
Typické znaky
- Tiskárna odmítá tisknout, i když je k dispozici inkoust
- Monitor stavu Epson zobrazuje upozornění na údržbu
- Blikající kontrolky a blokované úlohy
- Zařízení je uzamčeno, dokud není proveden reset
Reset Epson ET-2870 Waste Ink Counter in 3 Steps
- Krok 1: Connect Epson ET-2870 to a Windows computer with a stable Internet connection using a USB cable.
- Krok 2: Start Wic Reset Connect in Administrator mode and wait until Epson ET-2870 appears in the device list.
- Krok 3: Use the key to reset the counter, wait for completion, then restart Epson ET-2870 to finalize.
Most Epson ET-2870 waste counter resets finish in ~1–2 minutes.
Pokud tiskárna není detekována
- Používejte přímé připojení USB (vyhněte se rozbočovačům).
- Restartujte tiskárnu a počítač a zkuste to znovu.
- Spusťte aplikaci jako správce.
- Vyzkoušejte jiný kabel USB (některé kabely jsou pouze nabíjecí).
- Zavřete nástroj Epson Status Monitor nebo jiné nástroje tiskárny.
Guide prepared for Epson ET-2870 – Waste Ink Counter Reset using Wic Reset Connect.