Epson ET-2870 Waste Ink Counter Reset
When the Epson ET-2870 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.
During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2870 uses a software counter to estimate pad saturation and locks printing at a set threshold.
Understanding the Epson ET-2870 Waste Ink Counter
与 Wic Reset Connect, you can reset the Epson ET-2870 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.
典型标志
- 打印机即使有墨水也拒绝打印
- 爱普生状态监视器显示维护警告
- 闪烁的灯光和受阻的工作
- 设备被锁定，直到执行重置
Reset Epson ET-2870 Waste Ink Counter in 3 Steps
- 步骤 1： Connect Epson ET-2870 to a Windows computer with a stable Internet connection using a USB cable.
- 步骤 2： 开始 Wic Reset Connect in Administrator mode and wait until Epson ET-2870 appears in the device list.
- 步骤 3： Use the key to reset the counter, wait for completion, then restart Epson ET-2870 to finalize.
Most Epson ET-2870 waste counter resets finish in ~1–2 minutes.
如果检测不到打印机
- 使用直接 USB 连接（避免使用集线器）。.
- 重新启动打印机和电脑，然后再试一次。.
- 以管理员身份运行应用程序。.
- 试试另一条 USB 电缆（有些电缆只能充电）。.
- 关闭 Epson 状态监视器或其他打印机实用程序。.
Guide prepared for Epson ET-2870 – Waste Ink Counter Reset using Wic Reset Connect.