Epson ET-2870 Waste Ink Counter Reset
When the Epson ET-2870 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.
During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2870 uses a software counter to estimate pad saturation and locks printing at a set threshold.
Understanding the Epson ET-2870 Waste Ink Counter
Dengan Wic Reset Connect, you can reset the Epson ET-2870 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.
Tanda-tanda Khas
- Printer menolak untuk mencetak meskipun tinta tersedia
- Monitor Status Epson menunjukkan peringatan pemeliharaan
- Lampu berkedip dan pekerjaan terhalang
- Perangkat terkunci hingga pengaturan ulang dilakukan
Reset Epson ET-2870 Waste Ink Counter in 3 Steps
- Langkah 1: Connect Epson ET-2870 to a Windows computer with a stable Internet connection using a USB cable.
- Langkah 2: Mulai Wic Reset Connect in Administrator mode and wait until Epson ET-2870 appears in the device list.
- Langkah 3: Use the key to reset the counter, wait for completion, then restart Epson ET-2870 to finalize.
Most Epson ET-2870 waste counter resets finish in ~1–2 minutes.
Jika Printer Tidak Terdeteksi
- Gunakan koneksi USB langsung (hindari hub).
- Hidupkan ulang printer dan PC, kemudian coba lagi.
- Jalankan aplikasi sebagai Administrator.
- Coba kabel USB yang lain (beberapa kabel hanya untuk mengisi daya).
- Tutup Epson Status Monitor atau utilitas printer lainnya.
Guide prepared for Epson ET-2870 – Waste Ink Counter Reset using Wic Reset Connect.