Epson DX4000 Waste Ink Counter Reset

When the Epson DX4000 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson DX4000 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson DX4000 Waste Ink Counter

Most Epson DX4000 waste ink counter locks are solved by a software counter reset. Wic Reset Connect 提供了一个简单明了的程序。.

Reset Epson DX4000 Waste Ink Counter in 3 Steps

1. 步骤 1： Prepare a Windows PC + USB cable and connect Epson DX4000 directly. Keep Internet enabled for validation.
2. 步骤 2： 开始 Wic Reset Connect in Administrator mode and wait until Epson DX4000 appears in the device list.
3. 步骤 3： 输入重置密钥并按 重置. Wait ~1–2 minutes, then restart Epson DX4000.

Most Epson DX4000 waste counter resets finish in ~1–2 minutes.

您需要什么

• Windows 7/8/10/11 电脑
• 重置期间稳定的互联网连接
• 需要 USB 连接（不支持 Wi-Fi 重置）
• 有效 Wic 复位连接复位键

如果检测不到打印机

• 试试另一条 USB 电缆（有些电缆只能充电）。.
• 关闭 Epson 状态监视器或其他打印机实用程序。.
• 以管理员身份运行应用程序。.
• 重新启动打印机和电脑，然后再试一次。.
• 使用直接 USB 连接（避免使用集线器）。.

常见问题