Epson DX4000 Waste Ink Counter Reset

When the Epson DX4000 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson DX4000 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson DX4000 Waste Ink Counter

Most Epson DX4000 waste ink counter locks are solved by a software counter reset. Wic Reset Connect Pruža jednostavan postupak.

Reset Epson DX4000 Waste Ink Counter in 3 Steps

1. Korak 1: Prepare a Windows PC + USB cable and connect Epson DX4000 directly. Keep Internet enabled for validation.
2. Korak 2: Počni Wic Reset Connect in Administrator mode and wait until Epson DX4000 appears in the device list.
3. Korak 3: Unesite svoj ključ za resetiranje i pritisnite Ponovno pokretanje. Wait ~1–2 minutes, then restart Epson DX4000.

Most Epson DX4000 waste counter resets finish in ~1–2 minutes.

Što vam je potrebno

• Windows 7/8/10/11 PC
• Stabilna internetska veza tijekom resetiranja
• Potrebna je USB veza (ne podržava se resetiranje putem Wi-Fi-ja)
• Valjani Wic resetni ključ za povezivanje

Ako se pisač ne detektira

• Isprobajte drugi USB kabel (neki kabeli služe samo za punjenje).
• Zatvorite Epson Status Monitor ili druge uslužne programe za pisač.
• Pokrenite aplikaciju kao administrator.
• Ponovno pokrenite pisač i računalo, zatim pokušajte ponovno.
• Koristite izravno USB-povezivanje (izbjegavajte USB-hubove).

Često postavljana pitanja