Epson DX4000 Waste Ink Counter Reset

When the Epson DX4000 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson DX4000 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson DX4000 Waste Ink Counter

Most Epson DX4000 waste ink counter locks are solved by a software counter reset. Wic Reset Connect menyediakan prosedur yang mudah.

Reset Epson DX4000 Waste Ink Counter in 3 Steps

1. Langkah 1: Prepare a Windows PC + USB cable and connect Epson DX4000 directly. Keep Internet enabled for validation.
2. Langkah 2: Mulai Wic Reset Connect in Administrator mode and wait until Epson DX4000 appears in the device list.
3. Langkah 3: Masukkan tombol atur ulang dan tekan Atur ulang. Wait ~1–2 minutes, then restart Epson DX4000.

Most Epson DX4000 waste counter resets finish in ~1–2 minutes.

Apa yang Anda Butuhkan

• Windows 7/8/10/11 PC
• Koneksi Internet stabil selama pengaturan ulang
• Diperlukan koneksi USB (pengaturan ulang Wi-Fi tidak didukung)
• Tombol reset Wic Reset yang valid Hubungkan tombol reset

Jika Printer Tidak Terdeteksi

• Coba kabel USB yang lain (beberapa kabel hanya untuk mengisi daya).
• Tutup Epson Status Monitor atau utilitas printer lainnya.
• Jalankan aplikasi sebagai Administrator.
• Hidupkan ulang printer dan PC, kemudian coba lagi.
• Gunakan koneksi USB langsung (hindari hub).

Pertanyaan yang Sering Diajukan