Epson DX4000 Waste Ink Counter Reset

When the Epson DX4000 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson DX4000 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson DX4000 Waste Ink Counter

Most Epson DX4000 waste ink counter locks are solved by a software counter reset. Wic Reset Connect omogoča enostaven postopek.

Reset Epson DX4000 Waste Ink Counter in 3 Steps

1. 1. korak: Prepare a Windows PC + USB cable and connect Epson DX4000 directly. Keep Internet enabled for validation.
2. 2. korak: Začetek Wic Reset Connect in Administrator mode and wait until Epson DX4000 appears in the device list.
3. 3. korak: Vnesite ključ za ponastavitev in pritisnite Ponastavitev. Wait ~1–2 minutes, then restart Epson DX4000.

Most Epson DX4000 waste counter resets finish in ~1–2 minutes.

Kaj potrebujete

• Windows 7/8/10/11 PC
• Stabilna internetna povezava med ponastavitvijo
• Zahtevana je povezava USB (ponastavitev Wi-Fi ni podprta)
• Veljavna ponastavitev Wic Povežite tipko za ponastavitev

Če tiskalnik ni zaznan

• Poskusite z drugim kablom USB (nekateri kabli so namenjeni samo polnjenju).
• Zaprite Epson Status Monitor ali druge pripomočke za tiskalnik.
• Aplikacijo zaženite kot skrbnik.
• Ponovno zaženite tiskalnik in računalnik ter poskusite znova.
• Uporabite neposredno povezavo USB (izogibajte se vozliščem).

Pogosto zastavljena vprašanja