Epson B30 Waste Ink Counter Reset

If your Epson B30 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson B30 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson B30 Stops Printing (Waste Counter Limit)

Most Epson B30 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Three Steps to Restore Epson B30 Printing

1. Fase 1: Use a Windows PC (7–11) with Internet access. Connect Epson B30 via USB (Wi-Fi reset is not supported).
2. Fase 2: Start Wic Reset Connect in Administrator mode and wait until Epson B30 appears in the device list.
3. Fase 3: Paste the reset key, click Reset, and after completion power-cycle Epson B30.

Most Epson B30 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.