Epson B30 Waste Ink Counter Reset

If your Epson B30 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson B30 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson B30 Stops Printing (Waste Counter Limit)

Most Epson B30 waste ink counter locks are solved by a software counter reset. Wic Reset Connect giver en ligetil procedure.

Three Steps to Restore Epson B30 Printing

1. Trin 1: Use a Windows PC (7–11) with Internet access. Connect Epson B30 via USB (Wi-Fi reset is not supported).
2. Trin 2: Start Wic Reset Connect in Administrator mode and wait until Epson B30 appears in the device list.
3. Trin 3: Indsæt nulstillingsnøglen, klik på Nulstil, and after completion power-cycle Epson B30.

Most Epson B30 waste counter resets finish in ~1–2 minutes.

Hvis printeren ikke registreres

• Brug en direkte USB-forbindelse (undgå hubs).
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Prøv et andet USB-kabel (nogle kabler er kun til opladning).
• Kør appen som administrator.
• Luk Epson Status Monitor eller andre printerværktøjer.