Epson ET-2702 Waste Ink Counter Reset
When the Epson ET-2702 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.
The Epson ET-2702 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.
What Causes the Epson ET-2702 Ink Pad Counter Warning?
Most Epson ET-2702 waste ink counter locks are solved by a software counter reset. Wic Reset Connect poskytuje jednoduchý postup.
Three Steps to Restore Epson ET-2702 Printing
- Krok 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-2702 via USB (Wi-Fi reset is not supported).
- Krok 2: Štart Wic Reset Connect in Administrator mode and wait until Epson ET-2702 appears in the device list.
- Krok 3: Vložte resetovací kľúč, kliknite na Obnovenie, and after completion power-cycle Epson ET-2702.
Most Epson ET-2702 waste counter resets finish in ~1–2 minutes.
Čo potrebujete
- Vyžaduje sa pripojenie USB (resetovanie Wi-Fi nie je podporované)
- Platný kľúč na resetovanie Wic Connect
- Windows 7/8/10/11 PC
- Stabilné internetové pripojenie počas resetovania
Často kladené otázky
Môžem resetovať cez Wi-Fi?
Nie. Resetovanie vyžaduje pripojenie USB k počítaču so systémom Windows.
Čo ak resetovanie nefunguje?
Skontrolujte kábel/port USB, spustite ho ako správca a zatvorte ostatné nástroje tlačiarne.
Potrebujem servisné stredisko?
Zvyčajne nie pre zámok počítadla odpadového atramentu; zvyčajne stačí reset.
Ako dlho to trvá?
Zvyčajne približne 1-2 minúty.
Guide prepared for Epson ET-2702 – Waste Ink Counter Reset using Wic Reset Connect.