Epson SX110 Waste Ink Counter Reset

The Epson SX110 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson SX110 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson SX110 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson SX110 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Epson SX110 Ink Pad Counter Reset – Quick Steps

1. Pasul 1: Use a Windows PC (7–11) with Internet access. Connect Epson SX110 via USB (Wi-Fi reset is not supported).
2. Pasul 2: Start Wic Reset Connect in Administrator mode and wait until Epson SX110 appears in the device list.
3. Pasul 3: Use the key to reset the counter, wait for completion, then restart Epson SX110 to finalize.

Most Epson SX110 waste counter resets finish in ~1–2 minutes.

Troubleshooting

• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.