Epson TX102 Waste Ink Counter Reset

When the Epson TX102 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX102 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson TX102 Stops Printing (Waste Counter Limit)

Dengan Wic Reset Connect, you can reset the Epson TX102 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Bagaimana Kesalahan Muncul

• ‘Pesan ’Diperlukan Servis' / masa pakai dalam driver atau utilitas
• Kode pemeliharaan/dukungan (bervariasi menurut model/driver)
• Pencetakan berhenti setelah siklus pembersihan
• Peringatan berulang setelah printer dihidupkan ulang

Reset Epson TX102 Waste Ink Counter in 3 Steps

1. Langkah 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX102 via USB (Wi-Fi reset is not supported).
2. Langkah 2: Jalankan Wic Reset Connect as Administrator and confirm Epson TX102 is detected.
3. Langkah 3: Rekatkan tombol atur ulang, klik Atur ulang, and after completion power-cycle Epson TX102.

Most Epson TX102 waste counter resets finish in ~1–2 minutes.

Perbaikan Umum

• Coba kabel USB yang lain (beberapa kabel hanya untuk mengisi daya).
• Hidupkan ulang printer dan PC, kemudian coba lagi.
• Jalankan aplikasi sebagai Administrator.
• Nonaktifkan VPN/proxy untuk sementara waktu jika validasi gagal.
• Tutup Epson Status Monitor atau utilitas printer lainnya.

Pertanyaan yang Sering Diajukan