Epson TX102 Waste Ink Counter Reset

When the Epson TX102 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX102 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson TX102 Stops Printing (Waste Counter Limit)

S Wic Reset Connect, you can reset the Epson TX102 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Kako se pogreška prikazuje

• ‘Potreban servis’ / poruka o vijeku trajanja u upravljačkom programu ili korisničkom sučelju
• Kôd za održavanje/podršku (razlikuje se ovisno o modelu/vozaču)
• Tiskanje se zaustavlja nakon ciklusa čišćenja
• Upozorenje se ponavlja nakon ponovnog pokretanja pisača

Reset Epson TX102 Waste Ink Counter in 3 Steps

1. Korak 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX102 via USB (Wi-Fi reset is not supported).
2. Korak 2: Trči Wic Reset Connect as Administrator and confirm Epson TX102 is detected.
3. Korak 3: Umetnite reset-ključ i kliknite Ponovno pokretanje, and after completion power-cycle Epson TX102.

Most Epson TX102 waste counter resets finish in ~1–2 minutes.

Uobičajena rješenja

• Isprobajte drugi USB kabel (neki kabeli služe samo za punjenje).
• Ponovno pokrenite pisač i računalo, zatim pokušajte ponovno.
• Pokrenite aplikaciju kao administrator.
• Privremeno onemogućite VPN/proxy ako provjera ne uspije.
• Zatvorite Epson Status Monitor ili druge uslužne programe za pisač.

Često postavljana pitanja