Epson TX102 Waste Ink Counter Reset

When the Epson TX102 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX102 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson TX102 Stops Printing (Waste Counter Limit)

Koos Wic Reset Connect, you can reset the Epson TX102 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Kuidas viga ilmneb

• ‘Service Required’ / service life sõnum draiveris või kommunaalprogrammis
• Hooldus-/tugikood (varieerub mudelite/ajurite kaupa)
• Pärast puhastustsükleid peatub printimine
• Hoiatus kordub pärast printeri taaskäivitamist

Reset Epson TX102 Waste Ink Counter in 3 Steps

1. 1. samm: Use a Windows PC (7–11) with Internet access. Connect Epson TX102 via USB (Wi-Fi reset is not supported).
2. 2. samm: Käivita Wic Reset Connect as Administrator and confirm Epson TX102 is detected.
3. 3. samm: Sisestage lähtestamise võti, klõpsake Reset, and after completion power-cycle Epson TX102.

Most Epson TX102 waste counter resets finish in ~1–2 minutes.

Ühised parandused

• Proovige teist USB-kaablit (mõned kaablid on ainult laadimiseks).
• Käivitage printer ja arvuti uuesti, seejärel proovige uuesti.
• Käivitage rakendus administraatorina.
• VPN/proxy ajutiselt välja lülitada, kui valideerimine ebaõnnestub.
• Sulgege Epson Status Monitor või muud printeri utiliidid.

Korduma kippuvad küsimused