Epson TX102 Waste Ink Counter Reset

When the Epson TX102 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX102 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson TX102 Stops Printing (Waste Counter Limit)

Med Wic Reset Connect, you can reset the Epson TX102 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Hvordan fejlen opstår

• ‘Service påkrævet’/meddelelse om levetid i driver eller hjælpeprogram
• Vedligeholdelses-/supportkode (varierer efter model/driver)
• Udskrivning stopper efter rengøringscyklusser
• Advarslen gentages efter genstart af printeren

Reset Epson TX102 Waste Ink Counter in 3 Steps

1. Trin 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX102 via USB (Wi-Fi reset is not supported).
2. Trin 2: Løb Wic Reset Connect as Administrator and confirm Epson TX102 is detected.
3. Trin 3: Indsæt nulstillingsnøglen, klik på Nulstil, and after completion power-cycle Epson TX102.

Most Epson TX102 waste counter resets finish in ~1–2 minutes.

Almindelige rettelser

• Prøv et andet USB-kabel (nogle kabler er kun til opladning).
• Genstart printeren og pc'en, og prøv igen.
• Kør appen som administrator.
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Luk Epson Status Monitor eller andre printerværktøjer.

Ofte stillede spørgsmål