Epson ET-2713 Waste Ink Counter Reset
When the Epson ET-2713 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.
During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2713 uses a software counter to estimate pad saturation and locks printing at a set threshold.
Why Does the Epson ET-2713 Show ‘Service Required’?
Dengan Wic Reset Connect, you can reset the Epson ET-2713 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.
Epson ET-2713 Ink Pad Counter Reset – Quick Steps
- Langkah 1: Connect Epson ET-2713 to a Windows computer with a stable Internet connection using a USB cable.
- Langkah 2: Mulai Wic Reset Connect in Administrator mode and wait until Epson ET-2713 appears in the device list.
- Langkah 3: Masukkan tombol atur ulang dan tekan Atur ulang. Wait ~1–2 minutes, then restart Epson ET-2713.
Most Epson ET-2713 waste counter resets finish in ~1–2 minutes.
Persyaratan Sistem
- Diperlukan koneksi USB (pengaturan ulang Wi-Fi tidak didukung)
- Tombol reset Wic Reset yang valid Hubungkan tombol reset
- Windows 7/8/10/11 PC
- Koneksi Internet stabil selama pengaturan ulang
Jika Printer Tidak Terdeteksi
- Gunakan koneksi USB langsung (hindari hub).
- Jalankan aplikasi sebagai Administrator.
- Hidupkan ulang printer dan PC, kemudian coba lagi.
- Coba kabel USB yang lain (beberapa kabel hanya untuk mengisi daya).
- Nonaktifkan VPN/proxy untuk sementara waktu jika validasi gagal.
Guide prepared for Epson ET-2713 – Waste Ink Counter Reset using Wic Reset Connect.