Epson ET-2713 Waste Ink Counter Reset

When the Epson ET-2713 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2713 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson ET-2713 Show ‘Service Required’?

S Wic Reset Connect, you can reset the Epson ET-2713 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Epson ET-2713 Ink Pad Counter Reset – Quick Steps

1. Korak 1: Connect Epson ET-2713 to a Windows computer with a stable Internet connection using a USB cable.
2. Korak 2: Počni Wic Reset Connect in Administrator mode and wait until Epson ET-2713 appears in the device list.
3. Korak 3: Unesite svoj ključ za resetiranje i pritisnite Ponovno pokretanje. Wait ~1–2 minutes, then restart Epson ET-2713.

Most Epson ET-2713 waste counter resets finish in ~1–2 minutes.

Sistemski zahtjevi

• Potrebna je USB veza (ne podržava se resetiranje putem Wi-Fi-ja)
• Valjani Wic resetni ključ za povezivanje
• Windows 7/8/10/11 PC
• Stabilna internetska veza tijekom resetiranja

Ako se pisač ne detektira

• Koristite izravno USB-povezivanje (izbjegavajte USB-hubove).
• Pokrenite aplikaciju kao administrator.
• Ponovno pokrenite pisač i računalo, zatim pokušajte ponovno.
• Isprobajte drugi USB kabel (neki kabeli služe samo za punjenje).
• Privremeno onemogućite VPN/proxy ako provjera ne uspije.