Epson ET-2408 Waste Ink Counter Reset

If your Epson ET-2408 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2408 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson ET-2408 Show ‘Service Required’?

Koos Wic Reset Connect, you can reset the Epson ET-2408 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Three Steps to Restore Epson ET-2408 Printing

1. 1. samm: Prepare a Windows PC + USB cable and connect Epson ET-2408 directly. Keep Internet enabled for validation.
2. 2. samm: Start Wic Reset Connect in Administrator mode and wait until Epson ET-2408 appears in the device list.
3. 3. samm: Sisestage lähtestamise võti, klõpsake Reset, and after completion power-cycle Epson ET-2408.

Most Epson ET-2408 waste counter resets finish in ~1–2 minutes.

Mida te vajate

• Vajalik USB-ühendus (Wi-Fi lähtestamine ei ole toetatud)
• Windows 7/8/10/11 PC
• Kehtiv Wic Reset Connect reset key
• Stabiilne Interneti-ühendus reseti ajal

Kui printerit ei tuvastata

• Kasutage otsest USB-ühendust (vältige keskusi).
• Käivitage printer ja arvuti uuesti, seejärel proovige uuesti.
• Käivitage rakendus administraatorina.
• Sulgege Epson Status Monitor või muud printeri utiliidid.
• Proovige teist USB-kaablit (mõned kaablid on ainult laadimiseks).

KKK