Epson ET-2408 Waste Ink Counter Reset

If your Epson ET-2408 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2408 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson ET-2408 Show ‘Service Required’?

Med Wic Reset Connect, you can reset the Epson ET-2408 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Three Steps to Restore Epson ET-2408 Printing

1. Trin 1: Prepare a Windows PC + USB cable and connect Epson ET-2408 directly. Keep Internet enabled for validation.
2. Trin 2: Start Wic Reset Connect in Administrator mode and wait until Epson ET-2408 appears in the device list.
3. Trin 3: Indsæt nulstillingsnøglen, klik på Nulstil, and after completion power-cycle Epson ET-2408.

Most Epson ET-2408 waste counter resets finish in ~1–2 minutes.

Hvad du har brug for

• USB-forbindelse påkrævet (Wi-Fi-nulstilling understøttes ikke)
• Windows 7/8/10/11 PC
• Gyldig Wic-nulstilling Tilslut nulstillingsnøgle
• Stabil internetforbindelse under nulstilling

Hvis printeren ikke registreres

• Brug en direkte USB-forbindelse (undgå hubs).
• Genstart printeren og pc'en, og prøv igen.
• Kør appen som administrator.
• Luk Epson Status Monitor eller andre printerværktøjer.
• Prøv et andet USB-kabel (nogle kabler er kun til opladning).

OFTE STILLEDE SPØRGSMÅL