Epson ET-2408 Waste Ink Counter Reset

If your Epson ET-2408 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2408 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson ET-2408 Show ‘Service Required’?

S Wic Reset Connect, you can reset the Epson ET-2408 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Three Steps to Restore Epson ET-2408 Printing

1. Korak 1: Prepare a Windows PC + USB cable and connect Epson ET-2408 directly. Keep Internet enabled for validation.
2. Korak 2: Počni Wic Reset Connect in Administrator mode and wait until Epson ET-2408 appears in the device list.
3. Korak 3: Umetnite reset-ključ i kliknite Ponovno pokretanje, and after completion power-cycle Epson ET-2408.

Most Epson ET-2408 waste counter resets finish in ~1–2 minutes.

Što vam je potrebno

• Potrebna je USB veza (ne podržava se resetiranje putem Wi-Fi-ja)
• Windows 7/8/10/11 PC
• Valjani Wic resetni ključ za povezivanje
• Stabilna internetska veza tijekom resetiranja

Ako se pisač ne detektira

• Koristite izravno USB-povezivanje (izbjegavajte USB-hubove).
• Ponovno pokrenite pisač i računalo, zatim pokušajte ponovno.
• Pokrenite aplikaciju kao administrator.
• Zatvorite Epson Status Monitor ili druge uslužne programe za pisač.
• Isprobajte drugi USB kabel (neki kabeli služe samo za punjenje).

Često postavljana pitanja