Epson ET-2408 Waste Ink Counter Reset

If your Epson ET-2408 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2408 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson ET-2408 Show ‘Service Required’?

Con Wic Reset Connect, you can reset the Epson ET-2408 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Three Steps to Restore Epson ET-2408 Printing

1. Paso 1: Prepare a Windows PC + USB cable and connect Epson ET-2408 directly. Keep Internet enabled for validation.
2. Paso 2: Inicio Wic Reset Connect in Administrator mode and wait until Epson ET-2408 appears in the device list.
3. Paso 3: Pega la clave de reinicio, pulsa Restablecer, and after completion power-cycle Epson ET-2408.

Most Epson ET-2408 waste counter resets finish in ~1–2 minutes.

Lo que necesita

• Requiere conexión USB (no admite restablecimiento Wi-Fi)
• Windows 7/8/10/11 PC
• Válido Wic Reset Conectar tecla de reinicio
• Conexión a Internet estable durante el reinicio

Si no se detecta la impresora

• Utiliza una conexión USB directa (evita los concentradores).
• Reinicie la impresora y el PC y vuelva a intentarlo.
• Ejecute la aplicación como Administrador.
• Cierre Epson Status Monitor u otras utilidades de la impresora.
• Prueba con otro cable USB (algunos cables son de carga).

PREGUNTAS FRECUENTES