Epson ET-2408 Waste Ink Counter Reset

If your Epson ET-2408 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2408 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson ET-2408 Show ‘Service Required’?

S spletno stranjo Wic Reset Connect, you can reset the Epson ET-2408 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Three Steps to Restore Epson ET-2408 Printing

1. 1. korak: Prepare a Windows PC + USB cable and connect Epson ET-2408 directly. Keep Internet enabled for validation.
2. 2. korak: Začetek Wic Reset Connect in Administrator mode and wait until Epson ET-2408 appears in the device list.
3. 3. korak: Prilepite ključ za ponastavitev, kliknite Ponastavitev, and after completion power-cycle Epson ET-2408.

Most Epson ET-2408 waste counter resets finish in ~1–2 minutes.

Kaj potrebujete

• Zahtevana je povezava USB (ponastavitev Wi-Fi ni podprta)
• Windows 7/8/10/11 PC
• Veljavna ponastavitev Wic Povežite tipko za ponastavitev
• Stabilna internetna povezava med ponastavitvijo

Če tiskalnik ni zaznan

• Uporabite neposredno povezavo USB (izogibajte se vozliščem).
• Ponovno zaženite tiskalnik in računalnik ter poskusite znova.
• Aplikacijo zaženite kot skrbnik.
• Zaprite Epson Status Monitor ali druge pripomočke za tiskalnik.
• Poskusite z drugim kablom USB (nekateri kabli so namenjeni samo polnjenju).

POGOSTA VPRAŠANJA