Epson ET-2851 Ink Pad Counter Reset Guide

Epson ET-2851 Waste Ink Counter Reset

When the Epson ET-2851 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2851 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson ET-2851 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson ET-2851 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

‘Service Required’ / service life message in driver or utility
Maintenance/support code (varies by model/driver)
Printing stops after cleaning cycles
Warning repeats after restarting the printer

Three Steps to Restore Epson ET-2851 Printing

Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-2851 via USB (Wi-Fi reset is not supported).
Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson ET-2851 appears in the device list.
Step 3: Use the key to reset the counter, wait for completion, then restart Epson ET-2851 to finalize.

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson ET-2851 waste counter resets finish in ~1–2 minutes.

What You Need

Stable Internet connection during reset
USB connection required (Wi-Fi reset not supported)
Valid Wic Reset Connect reset key
Windows 7/8/10/11 PC

Frequently Asked Questions

What if reset doesn’t work?

Check USB cable/port, run as admin, and close other printer utilities.

Do I need a service center?

Typically not for a waste ink counter lock; a reset is usually sufficient.

Can I reset over Wi-Fi?

No. The reset requires a USB connection to a Windows PC.

How long does it take?

Usually about 1–2 minutes.

Guide prepared for Epson ET-2851 – Waste Ink Counter Reset using Wic Reset Connect.