Fix Epson TX113 Service Required – Waste Counter Reset

Epson TX113 Waste Ink Counter Reset

When the Epson TX113 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX113 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson TX113 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson TX113 waste counter reset in minutes.

Three Steps to Restore Epson TX113 Printing

  1. Schritt 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX113 via USB (Wi-Fi reset is not supported).
  2. Schritt 2: Run Wic Reset Connect as Administrator and confirm Epson TX113 is detected.
  3. Schritt 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX113.
Buy Reset Key ⬇️ Download Wic Reset Connect Anweisungen

Most Epson TX113 waste counter resets finish in ~1–2 minutes.

Common Fixes

  • Restart printer and PC, then try again.
  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.
  • Run the app as Administrator.
  • Temporarily disable VPN/proxy if validation fails.

Frequently Asked Questions

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson TX113 – Waste Ink Counter Reset using Wic Reset Connect.

Warenkorb