Epson TX113 Waste Ink Counter Reset
When the Epson TX113 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.
During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX113 uses a software counter to estimate pad saturation and locks printing at a set threshold.
What Causes the Epson TX113 Ink Pad Counter Warning?
Servisni obisk pogosto ni potreben. Wic Reset Connect allows a safe Epson TX113 waste counter reset in minutes.
Three Steps to Restore Epson TX113 Printing
- 1. korak: Use a Windows PC (7–11) with Internet access. Connect Epson TX113 via USB (Wi-Fi reset is not supported).
- 2. korak: Spustite Wic Reset Connect as Administrator and confirm Epson TX113 is detected.
- 3. korak: Vnesite ključ za ponastavitev in pritisnite Ponastavitev. Wait ~1–2 minutes, then restart Epson TX113.
Most Epson TX113 waste counter resets finish in ~1–2 minutes.
Pogosti popravki
- Ponovno zaženite tiskalnik in računalnik ter poskusite znova.
- Poskusite z drugim kablom USB (nekateri kabli so namenjeni samo polnjenju).
- Zaprite Epson Status Monitor ali druge pripomočke za tiskalnik.
- Aplikacijo zaženite kot skrbnik.
- Začasno onemogočite VPN/proxy, če preverjanje ni uspešno.
Pogosto zastavljena vprašanja
Kaj če ponastavitev ne deluje?
Preverite kabel/port USB, zaženite ga kot upravitelj in zaprite druge pripomočke za tiskalnik.
Ali lahko ponastavitev izvedem prek omrežja Wi-Fi?
Ne. Ponastavitev zahteva povezavo USB z računalnikom Windows.
Koliko časa traja?
Običajno približno 1-2 minuti.
Ali potrebujem servisni center?
Običajno ne za zaklep števca za odpadno črnilo; ponavadi zadostuje ponastavitev.
Guide prepared for Epson TX113 – Waste Ink Counter Reset using Wic Reset Connect.