Epson TX113 Waste Ink Counter Reset
When the Epson TX113 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.
During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX113 uses a software counter to estimate pad saturation and locks printing at a set threshold.
What Causes the Epson TX113 Ink Pad Counter Warning?
通常不需要上门服务。. Wic Reset Connect allows a safe Epson TX113 waste counter reset in minutes.
Three Steps to Restore Epson TX113 Printing
- 步骤 1： Use a Windows PC (7–11) with Internet access. Connect Epson TX113 via USB (Wi-Fi reset is not supported).
- 步骤 2： 运行 Wic Reset Connect as Administrator and confirm Epson TX113 is detected.
- 步骤 3： 输入重置密钥并按 重置. Wait ~1–2 minutes, then restart Epson TX113.
Most Epson TX113 waste counter resets finish in ~1–2 minutes.
常见修复
- 重新启动打印机和电脑，然后再试一次。.
- 试试另一条 USB 电缆（有些电缆只能充电）。.
- 关闭 Epson 状态监视器或其他打印机实用程序。.
- 以管理员身份运行应用程序。.
- 如果验证失败，则暂时禁用 VPN/代理。.
常见问题
如果重置不起作用怎么办？
检查 USB 电缆/端口，以管理员身份运行，并关闭其他打印机实用程序。.
可以通过 Wi-Fi 重置吗？
重置需要通过 USB 连接到 Windows PC。.
需要多长时间？
通常约 1-2 分钟。.
我需要服务中心吗？
通常不用于废墨计数器锁；重置通常就足够了。.
Guide prepared for Epson TX113 – Waste Ink Counter Reset using Wic Reset Connect.