Epson ME-300 Waste Ink Counter Reset

When the Epson ME-300 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ME-300 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson ME-300 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson ME-300 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Step-by-Step: Epson ME-300 Waste Counter Reset

1. Krok 1: Use a Windows PC (7–11) with Internet access. Connect Epson ME-300 via USB (Wi-Fi reset is not supported).
2. Krok 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ME-300.
3. Krok 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ME-300.

Most Epson ME-300 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.