Epson ME-300 Waste Ink Counter Reset

When the Epson ME-300 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ME-300 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson ME-300 Waste Ink Counter

S Wic Reset Connect, you can reset the Epson ME-300 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Step-by-Step: Epson ME-300 Waste Counter Reset

1. Korak 1: Use a Windows PC (7–11) with Internet access. Connect Epson ME-300 via USB (Wi-Fi reset is not supported).
2. Korak 2: Otvoreno Wic Reset Connect with admin privileges and verify device recognition for Epson ME-300.
3. Korak 3: Unesite svoj ključ za resetiranje i pritisnite Ponovno pokretanje. Wait ~1–2 minutes, then restart Epson ME-300.

Most Epson ME-300 waste counter resets finish in ~1–2 minutes.

Ako se pisač ne detektira

• Isprobajte drugi USB kabel (neki kabeli služe samo za punjenje).
• Ponovno pokrenite pisač i računalo, zatim pokušajte ponovno.
• Pokrenite aplikaciju kao administrator.
• Koristite izravno USB-povezivanje (izbjegavajte USB-hubove).
• Privremeno onemogućite VPN/proxy ako provjera ne uspije.