Epson ME-300 Waste Ink Counter Reset

When the Epson ME-300 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ME-300 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson ME-300 Waste Ink Counter

Med Wic Reset Connect, you can reset the Epson ME-300 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Step-by-Step: Epson ME-300 Waste Counter Reset

1. Trin 1: Use a Windows PC (7–11) with Internet access. Connect Epson ME-300 via USB (Wi-Fi reset is not supported).
2. Trin 2: Åben Wic Reset Connect with admin privileges and verify device recognition for Epson ME-300.
3. Trin 3: Indtast din nulstillingsnøgle, og tryk på Nulstil. Wait ~1–2 minutes, then restart Epson ME-300.

Most Epson ME-300 waste counter resets finish in ~1–2 minutes.

Hvis printeren ikke registreres

• Prøv et andet USB-kabel (nogle kabler er kun til opladning).
• Genstart printeren og pc'en, og prøv igen.
• Kør appen som administrator.
• Brug en direkte USB-forbindelse (undgå hubs).
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.