Reset Epson TX102 Waste Ink Counter in Minutes

Epson TX102 Waste Ink Counter Reset

When the Epson TX102 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX102 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson TX102 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson TX102 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Reset Epson TX102 Waste Ink Counter in 3 Steps

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX102 via USB (Wi-Fi reset is not supported).
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson TX102 is detected.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson TX102.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson TX102 waste counter resets finish in ~1–2 minutes.

Common Fixes

  • Try another USB cable (some cables are charge-only).
  • Restart printer and PC, then try again.
  • Run the app as Administrator.
  • Temporarily disable VPN/proxy if validation fails.
  • Close Epson Status Monitor or other printer utilities.

Frequently Asked Questions

How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson TX102 – Waste Ink Counter Reset using Wic Reset Connect.

Корпа