Epson ET-2702 Ink Pad Counter Reset Guide

Epson ET-2702 Waste Ink Counter Reset

When the Epson ET-2702 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ET-2702 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson ET-2702 Ink Pad Counter Warning?

Most Epson ET-2702 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Three Steps to Restore Epson ET-2702 Printing

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-2702 via USB (Wi-Fi reset is not supported).
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson ET-2702 appears in the device list.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson ET-2702.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson ET-2702 waste counter resets finish in ~1–2 minutes.

What You Need

  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset

Frequently Asked Questions

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson ET-2702 – Waste Ink Counter Reset using Wic Reset Connect.

Shopping Cart