How to Reset Epson ET-2705 Waste Ink Counter

Epson ET-2705 Waste Ink Counter Reset

If your Epson ET-2705 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2705 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson ET-2705 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson ET-2705 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson ET-2705 Printing

  1. Schritt 1: Connect Epson ET-2705 to a Windows computer with a stable Internet connection using a USB cable.
  2. Schritt 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-2705.
  3. Schritt 3: Use the key to reset the counter, wait for completion, then restart Epson ET-2705 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Anweisungen

Most Epson ET-2705 waste counter resets finish in ~1–2 minutes.

Common Fixes

  • Try another USB cable (some cables are charge-only).
  • Use a direct USB connection (avoid hubs).
  • Restart printer and PC, then try again.
  • Temporarily disable VPN/proxy if validation fails.
  • Close Epson Status Monitor or other printer utilities.

Guide prepared for Epson ET-2705 – Waste Ink Counter Reset using Wic Reset Connect.

Warenkorb