Canon G3910 Ink Absorber Full Reset
The “Ink Absorber Full” / service required message on Canon G3910 is common after many cleaning cycles. In most cases, a counter reset restores printing.
During head cleaning, surplus ink is routed to internal absorber pads. Canon G3910 monitors this via a counter and can lock printing at a threshold.
This page is prepared for Canon G3910. Service mode instructions are shown only when a matching series procedure is known.
How to Enter Service Mode on Canon G3910
If your Canon G3910 supports service mode reset, follow the steps below before performing the counter reset.
- Bật máy in TẮT.
- Nhấn và giữ Dừng/Đặt lại.
- Trong khi giữ nút Stop/Reset, nhấn và giữ. Công suất.
- Phát hành Dừng/Đặt lại (Tiếp tục giữ nút Nguồn).
- Báo chí Dừng/Đặt lại 5 lần.
- Phát hành Công suất — Máy in nên chuyển sang chế độ dịch vụ.
Nếu không thành công, hãy lặp lại quy trình một cách cẩn thận. Số lần nhấn phụ thuộc vào từng dòng sản phẩm.
Hoàn tất quá trình đặt lại và khôi phục in ấn
Once the counter is cleared, Canon G3910 should exit the locked state and printing should resume normally.
Cảnh báo
Nếu các miếng thấm mực bị bão hòa hoàn toàn, việc bỏ qua bảo trì có thể dẫn đến rò rỉ mực bên trong máy in. Việc đặt lại bộ đếm chỉ loại bỏ khóa phần mềm.
Cần một giải pháp khôi phục cài đặt gốc?
Sử dụng kết nối USB đáng tin cậy và thực hiện các bước theo thứ tự.
Câu hỏi thường gặp
Guide prepared for Canon G3910 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.