Epson TX117 Waste Ink Counter Reset

When the Epson TX117 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX117 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson TX117 Stops Printing (Waste Counter Limit)

Med Wic Reset Connect, you can reset the Epson TX117 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Step-by-Step: Epson TX117 Waste Counter Reset

1. Steg 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX117 via USB (Wi-Fi reset is not supported).
2. Steg 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX117 appears in the device list.
3. Steg 3: Use the key to reset the counter, wait for completion, then restart Epson TX117 to finalize.

Most Epson TX117 waste counter resets finish in ~1–2 minutes.

Systemkrav

• Windows 7/8/10/11 PC
• USB-anslutning krävs (Wi-Fi-återställning stöds inte)
• Giltig Wic Reset Anslut återställningsknapp
• Stabil internetanslutning under återställning

Felsökning

• Kör appen som administratör.
• Använd en direkt USB-anslutning (undvik hubbar).
• Starta om skrivaren och datorn och försök sedan igen.
• Prova en annan USB-kabel (vissa kablar är endast laddningsbara).
• Inaktivera VPN/proxy tillfälligt om valideringen misslyckas.

VANLIGA FRÅGOR