Model-specific reset guide
Canon TS6050 Ink Absorber Full Reset
When Canon TS6050 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
What stops Canon TS6050 from printing
The absorber pads collect ink generated during print-head cleaning. Canon TS6050 tracks those maintenance cycles in memory rather than measuring the pads directly.
Wic Reset Connect is designed to reset the compatible counter in Canon TS6050. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS6050
- Turn the printer off.
- Tryck och håll in Stopp/återställning.
- Medan du håller Stop/Reset, tryck och håll in Kraft.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 gånger.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS6050
The counter reset normally takes only a few minutes after Canon TS6050 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS6050 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS6050 is not detected
- Connect Canon TS6050 directly to the computer and try another data-capable USB cable or port.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
Canon TS6050 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Hur många gånger ska jag trycka på Stop/Reset?
For Canon TS6050, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon TS6050
Complete the Canon TS6050 absorber counter reset in a few carefully prepared steps.