How to Reset Epson XP-7101 Waste Ink Counter

Epson XP-7101 Waste Ink Counter Reset

When the Epson XP-7101 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-7101 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson XP-7101 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson XP-7101 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

How the Error Appears

‘Service Required’ / service life message in driver or utility
Maintenance/support code (varies by model/driver)
Printing stops after cleaning cycles
Warning repeats after restarting the printer

Epson XP-7101 Ink Pad Counter Reset – Quick Steps

Krok 1: Prepare a Windows PC + USB cable and connect Epson XP-7101 directly. Keep Internet enabled for validation.
Krok 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson XP-7101.
Krok 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-7101.

Buy Reset Key ⬇️ Download Wic Reset Connect Pokyny

Most Epson XP-7101 waste counter resets finish in ~1–2 minutes.

Troubleshooting

Close Epson Status Monitor or other printer utilities.
Use a direct USB connection (avoid hubs).
Temporarily disable VPN/proxy if validation fails.
Try another USB cable (some cables are charge-only).
Restart printer and PC, then try again.

FAQ

How long does it take?

Usually about 1–2 minutes.

Do I need a service center?

Typically not for a waste ink counter lock; a reset is usually sufficient.

Can I reset over Wi-Fi?

No. The reset requires a USB connection to a Windows PC.

What if reset doesn’t work?

Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson XP-7101 – Waste Ink Counter Reset using Wic Reset Connect.