Epson B42WD Waste Ink Counter Reset

When the Epson B42WD reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson B42WD accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why the Epson B42WD Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson B42WD waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Epson B42WD Ink Pad Counter Reset – Quick Steps

1. Krok 1: Use a Windows PC (7–11) with Internet access. Connect Epson B42WD via USB (Wi-Fi reset is not supported).
2. Krok 2: Run Wic Reset Connect as Administrator and confirm Epson B42WD is detected.
3. Krok 3: Paste the reset key, click Reset, and after completion power-cycle Epson B42WD.

Most Epson B42WD waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

If the Printer Is Not Detected

• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.

FAQ