Model-specific reset guide
Úplný reset absorbéra atramentu Canon GM2010
The waste ink system in Canon GM2010 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
Understanding the Canon GM2010 ink absorber warning
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon GM2010 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon GM2010. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon GM2010
- Turn the printer off.
- Stlačte a podržte tlačidlo Zastavenie/resetovanie.
- Počas držania tlačidla Stop/Reset stlačte a podržte Napájanie.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5-krát.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon GM2010
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon GM2010 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon GM2010 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon GM2010 directly to the computer and try another data-capable USB cable or port.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon GM2010 reset FAQ
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Koľkokrát mám stlačiť tlačidlo Stop/Reset?
For Canon GM2010, use 5 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon GM2010
Prepare Canon GM2010, enter service mode and complete the reset with a valid Wic Reset Connect key.