Epson R360 Waste Ink Counter Reset

Epson R360 Waste Ink Counter Reset

The Epson R360 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

The Epson R360 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson R360 Waste Ink Counter

Most Epson R360 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Three Steps to Restore Epson R360 Printing

  1. Passo 1: Use a Windows PC (7–11) with Internet access. Connect Epson R360 via USB (Wi-Fi reset is not supported).
  2. Passo 2: Start Wic Reset Connect in Administrator mode and wait until Epson R360 appears in the device list.
  3. Etapa 3: Paste the reset key, click Reset, and after completion power-cycle Epson R360.
Buy Reset Key ⬇️ Download Wic Reset Connect Instruções

Most Epson R360 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset

Troubleshooting

  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).
  • Restart printer and PC, then try again.
  • Temporarily disable VPN/proxy if validation fails.

Frequently Asked Questions

How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson R360 – Waste Ink Counter Reset using Wic Reset Connect.

Carrinho de compras