Epson R360 Waste Ink Counter Reset

The Epson R360 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

The Epson R360 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson R360 Waste Ink Counter

Most Epson R360 waste ink counter locks are solved by a software counter reset. Wic Reset Connect ofrece un procedimiento sencillo.

Three Steps to Restore Epson R360 Printing

1. Paso 1: Use a Windows PC (7–11) with Internet access. Connect Epson R360 via USB (Wi-Fi reset is not supported).
2. Paso 2: Inicio Wic Reset Connect in Administrator mode and wait until Epson R360 appears in the device list.
3. Paso 3: Pega la clave de reinicio, pulsa Restablecer, and after completion power-cycle Epson R360.

Most Epson R360 waste counter resets finish in ~1–2 minutes.

Antes de empezar

• Requiere conexión USB (no admite restablecimiento Wi-Fi)
• Válido Wic Reset Conectar tecla de reinicio
• Windows 7/8/10/11 PC
• Conexión a Internet estable durante el reinicio

Solución de problemas

• Prueba con otro cable USB (algunos cables son de carga).
• Cierre Epson Status Monitor u otras utilidades de la impresora.
• Utiliza una conexión USB directa (evita los concentradores).
• Reinicie la impresora y el PC y vuelva a intentarlo.
• Desactivar temporalmente VPN/proxy si falla la validación.

Preguntas frecuentes