Model-specific reset guide
Canon TS8300 Ink Absorber Full Reset
Canon TS8300 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
The waste ink counter inside Canon TS8300
Cleaning operations send unused ink into absorber pads inside the printer. Canon TS8300 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon TS8300. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS8300
- Turn the printer off.
- Premir e manter premido Parar/Reiniciar.
- Enquanto mantém premido Stop/Reset, prima e mantenha premido Potência.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 vezes.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS8300
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS8300 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS8300 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
Canon TS8300 reset FAQ
Quantas vezes devo premir Stop/Reset?
For Canon TS8300, use 5 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon TS8300
Complete the Canon TS8300 absorber counter reset in a few carefully prepared steps.