How to Reset Epson XP-300 Waste Ink Counter

Epson XP-300 Waste Ink Counter Reset

The Epson XP-300 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-300 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson XP-300 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-300 waste counter reset in minutes.

Epson XP-300 Ink Pad Counter Reset – Quick Steps

Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson XP-300 via USB (Wi-Fi reset is not supported).
Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-300 appears in the device list.
Step 3: Use the key to reset the counter, wait for completion, then restart Epson XP-300 to finalize.

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson XP-300 waste counter resets finish in ~1–2 minutes.

Before You Begin

USB connection required (Wi-Fi reset not supported)
Valid Wic Reset Connect reset key
Windows 7/8/10/11 PC
Stable Internet connection during reset

If the Printer Is Not Detected

Run the app as Administrator.
Temporarily disable VPN/proxy if validation fails.
Use a direct USB connection (avoid hubs).
Try another USB cable (some cables are charge-only).
Restart printer and PC, then try again.

Frequently Asked Questions

Can I reset over Wi-Fi?

No. The reset requires a USB connection to a Windows PC.

What if reset doesn’t work?

Check USB cable/port, run as admin, and close other printer utilities.

Do I need a service center?

Typically not for a waste ink counter lock; a reset is usually sufficient.

How long does it take?

Usually about 1–2 minutes.

Guide prepared for Epson XP-300 – Waste Ink Counter Reset using Wic Reset Connect.