Epson XP-302 Waste Ink Counter Reset

When the Epson XP-302 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson XP-302 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why the Epson XP-302 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson XP-302 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson XP-302 Waste Counter Reset

1. 1. lépés: Use a Windows PC (7–11) with Internet access. Connect Epson XP-302 via USB (Wi-Fi reset is not supported).
2. 2. lépés: Start Wic Reset Connect in Administrator mode and wait until Epson XP-302 appears in the device list.
3. 3. lépés: Use the key to reset the counter, wait for completion, then restart Epson XP-302 to finalize.

Most Epson XP-302 waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key

Common Fixes

• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.

FAQ