How to Reset Ink Absorber on Canon E4270

Canon E4270 Ink Absorber Full Reset

When Canon E4270 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon E4270 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon E4270. Service mode instructions are shown only when a matching series procedure is known.

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

If It Doesn’t Work

Try a different USB cable/port if using PC software.
Close other Canon printer utilities while resetting.
Power-cycle the printer and try again.
Use the correct Stop/Reset press count for your series.
Repeat the service mode steps carefully (timing matters).

Frequently Asked Questions

How long does it take?

Usually a few minutes once the correct steps are followed.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon E4270 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.